A Review of Communication Protocols for Intelligent Remote Terminal Unit Development
Abstract
This paper reviewed all the possible interfacing communication protocols for remote terminal unit (RTU). Supervisory Control and Data Acquisition (SCADA) system is a central station that can communicate with other network using the protocol. Fundamentally, the architectures of all networks are based on the seven layers of open system interconnection (OSI) and International Standard Organization (ISO). The objective of designing the protocols is to check the status of all the input and output field devices and send the report according to that status. The corresponding protocol and communication parameters between the connecting devices will be included in designing a complex SCADA system. The available protocols to develop the communication of RTU are Modbus/ASCII, distributed network protocol (DNP3), controller area network (CAN), International Electro-technical Commission (IEC 60870), and transmission control protocol/internet protocol (TCP/IP).
Full Text:
PDFReferences
M.M Ahmed, W.L Soo, M. A. M. Hanafiah and M. R. A. Ghani., Development of Customized Distribution Automation System (DAS) for Secure Fault Isolation in Low Voltage Distribution Automation in Luiz Affonso Guides (Ed), Programmable Logic Controller, (Rijeka, Crotia, In Tech, 2010) 131-150.
M.M Ahmed, W.L Soo, M. A. M. Hanafiah and M. R. A. Ghani, Customized Fault Management System for Low Voltage (LV) Distribution Automation System in Wei Zhang (Ed), Fault Detection (Rijeka, Crotia, In Tech, 2010) 51-70.
W.N.S.E Wan Jusoh, M.A.M. Hanafiah, M.R.A. Ghani, S.H.Raman, Remote Terminal Unit (RTU) Hardware Design and Implementation Efficient in Difference Application. 2013 IEEE 7th International Power Engineering and Optimization Conference (PEOCO), Langkawi Malaysia, 3-4 June 2013, 570-573.
W.N.S.E Wan Jusoh, M.A. Mat Hanafiah, M.R. Ab. Ghani, A. Jidin, S.H. Raman, Development of Remote Terminal Unit (RTU) for the New Function of Distribution Automation System (DAS). Power and Energy Conversion Symposium (PECS 2012). Melaka Malaysia, 17 December 2012, 310-312.
S.H. Raman, M.R. Ab. Ghani, Z.A. Bharudin, M.A.M. Hanafiah, W.N.S.E. Wan Jusoh, The Implementation of fault Management in distribution Automation System Using Distribution Automation System (DAS) in Conjunction with SCADA. Power and Energy Conversion Symposium (PECS 2012), Melaka Malaysia, 17 December 2012, 305-309.
M.M Mat Hanafiah,S.H. Raman, W.N.S.E. Wan Jusoh, M.R. Ab Ghani, Z.A. Baharuddin, Development of a Novel Fault Management in Distribution System using Distribution Automation System in Conjunction with GSM Communication. International Journal of Smart Grid and Clean Energy. 2013; 2(3): 330-335.
John Rinaldi, An Introduction to Modbus RTU addressing, Function Code and Networking, 2010.
Ling Cheng, Study and Application of DNP3.0 in SCADA System. 2011 International Conferences on Electronic & Mechanical Engineering and Information Technology, 12-14 August 2011, 4563-4566.
Wilfried Voss, The Future of CAN/CAN open and the Industrial Ethernet Challenge, President esd electronics, Inc USA, 2011.
Sanchez. Using Internet Protocols to Implement IEC 60870-5 Tele-control Functions. IEEE Transactions on Power Delivery. 2010; 25(1): 407-406.
Himanshu Arora. TCP/IP Protocol Fundamental Explained with a Diagram. 2011.
Daogang Peng, Hao Zhang, Jiannian Weng, Hui Li, Fei Xia., Design and Development of Modbus/RTU Master Monitoring System Based on Embedded PowerPC Platform. IEEE International Symposium on Industrial Electronic (ISIE 2009). Seoul Olympic Parktel, Seoul, Korea, July 5-8, 2009, 2148-2152.
Rao Kalapatapu. Scada Protocol and communication trends, The Instrumentation System and Automation Society. Presented at the ISA 2004, 5-7 October 2004, Reliant Center Houston, Texas, 2004.
Product Information Note Experion DNP3 Interface, Jun 2009.
Bosch, CAN specification Ver 2.0, Robert Bosch GmbH, Stuttgart, Germany, Chuck Power Motorola MCTG Multiplex Application, 5 April 1995.
Sanjay Gupta, CAN facilities in Vehicle Networking, SAE paper 900695, 1995, pp. 9-16.
Mei Yang, Protocol Architecture TCP/IP and Internet Based Application, 25 August 2013.
Suphan Gulpanich, Arjin Numsomran, Vittaya Tipsuwanporn, Kitti Tirasesth. Distributed control of Network devices with Remote Terminal Unit. IEEE International Conference on Industrial Technology (ICIT 2005). Hong Kong. 2005: 823- 828.
DOI: http://doi.org/10.12928/telkomnika.v11i4.1206
Refbacks
- There are currently no refbacks.
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
TELKOMNIKA Telecommunication, Computing, Electronics and Control
ISSN: 1693-6930, e-ISSN: 2302-9293
Universitas Ahmad Dahlan, 4th Campus
Jl. Ringroad Selatan, Kragilan, Tamanan, Banguntapan, Bantul, Yogyakarta, Indonesia 55191
Phone: +62 (274) 563515, 511830, 379418, 371120
Fax: +62 274 564604